1.1 The objective of this test method is to determine the time over which rock bolt tension decreases from the installed value to a designated minimum value.
1.2 This test method is applicable to any anchor system which is not fully encapsulated immediately upon installation, including mechanical, cement grout, resin (epoxy, polyester, and the like) or other similar systems.
1.3 The values stated in inch-pound units are to be regarded as the standard.
1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.
1.4.1 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Product Details
- Published:
- 07/01/2004
- Number of Pages:
- 5
- File Size:
- 1 file , 48 KB
