Click here to purchase
1.1
This Standard covers plumbing waste fittings of sizes NPS-2 and smaller.
1.2
This Standard does not cover
(a) plumbing supply fittings, which are covered by ASME A112.18.1/CSA B125.1;
(b) other devices (e.g., temperature-actuated in-line mixing valves), which are covered by CSA B125.3 orother plumbing product standards; and
(c) flexible water connectors under continuous pressure, which are covered by ASME A112.18.6/CSA B125.6.
1.3
This Standard does not cover pipes and tubes or pipe and tube fittings that are downstream of the trap.
1.4
In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfyin order to comply with the standard; “should” is used to express a recommendation or that which isadvised but not required; and “may” is used to express an option or that which is permissible within thelimits of the standard.
Notes accompanying clauses do not include requirements or alternative requirements; the purpose of anote accompanying a clause is to separate from the text explanatory or informative material.
Notes to tables and figures are considered part of the table or figure and may be written asrequirements.
Annexes are designated normative (mandatory) or informative (nonmandatory) to define theirapplication.
1.5
SI units are the units of record in Canada. In this Standard, the inch/pound units are shown in parentheses.
The values stated in each measurement system are equivalent in application; however, each system is tobe used independently. Combining values from the two measurement systems can result innon-conformance with this Standard.
All references to gallons are to U.S. gallons.
For information on the conversion criteria used in this Standard, see Annex A.
Product Details
- Published:
- 08/01/2015
- ISBN(s):
- 9780791870457
- ANSI:
- ANSI Approved
- Number of Pages:
- 50
- File Size:
- 1 file , 880 KB
