Click here to purchase

1.1 This specification covers wrought-carbon steel butt-welding seamless or welded fittings specially processed to ensure better notch toughness than that to be expected in fittings manufactured to the requirements of Specification A234/A234M.

1.1.1 Included are elbows, caps, tees, reducers, and other type fittings covered by ASME B 16.9.

1.1.2 Heat treatment is required for all fittings.

1.1.3 Fittings with mandatory radiographic examination of welds are included.

1.1.4 Supplementary requirements are provided for use when additional testing or examination is desired.

1.1.5 Cast fittings, and fittings formed from all weld metal, are not included.

1.2 Several type of fittings are provided, as follows:

Type Heat Treatment RequiredWeld Seam Finish ()Radiography Required?
30 normalize UW-35 no
31 normalize UW-35 yes
32 normalize UW-35 and ground flush yes
40 normalize and temperUW-35 no
41 normalize and temperUW-35 yes
42 normalize and temperUW-35 and ground flush yes
50 quench and temperUW-35 no
51 quench and temperUW-35 yes
52 quench and temperUW-35 and ground flush yes

1.3 It shall be the responsibility of the purchaser to determine whether material meeting the requirements of this specification is satisfactory for the service application.

1.4 This specification is expressed in both inch-pound units and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Product Details

Published:
09/10/2000
Number of Pages:
5
File Size:
1 file , 40 KB

You may also like...