1.1 This practice covers the determination of indentation hardness of metallic materials using comparison hardness testers.
1.2 This practice applies only to those comparison hardness testers, normally portable, that use comparative test bars that have been standardized according to Test Method E 10 as a basis for comparison.
1.3 Calibration of comparative test bars (rods), used for comparison to determine hardness numbers, is also covered by this practice.
1.4 The impression force used during comparison hardness testing is normally an impact load applied by striking a hammer on the appropriate areas as outlined in the manufacturer’s instructions.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Product Details
- Published:
- 03/01/2008
- Number of Pages:
- 3
- File Size:
- 1 file , 62 KB
- Redline File Size:
- 2 files , 130 KB
