1.1 This specification covers circular contact-molded fiberglass reinforced-thermosetting-resin flanges for usein pipe systems and tank nozzles. Included are requirements for materials, workmanship, performance, anddimensions.
1.2 Flanges (see ) may be produced as integral flanges, Type A, or flange-on-pipe, Type B.
1.3 This specification is based on flange performance and does not cover design.
1.4 These flanges aredesigned for use with pipe and tanks that are manufactured to Specifications D 2996, D 2997, D 3262, D 3299, D3517, D 3754, D 3982, and D 4097.
1.5 Selection of gaskets is not covered in this specification, refer tothe manufacturer’s recommendation. Note 1 – ISO Equivalent: There is no similar or equivalent ISO standard.
1.6 The values stated in inch-pound units are to be regarded as the standard. The SI units given inparentheses are for information only.
1.7 The following precautionary caveat pertains only to the testmethods portion of this specification:
This standard does not purport to address the safetyproblems, if any, associated with its use. It is the responsibility of the user of this standard to establishappropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Product Details
- Published:
- 07/01/2005
- Number of Pages:
- 5
- File Size:
- 1 file , 100 KB
- Redline File Size:
- 2 files , 190 KB
